Turning a new page for the Nude GPR
Posted: Tue Nov 21, 2017 3:45 pm
My bike decided to lock up the rear brakes as I was going into a sharp speed bump and I didnt handle it very well. Fairings are done. Handlebar is bent. And its stuck on full throttle. And I have no trust in the brakes anymore.
So now I've decided that I might as well turn it into a project bike.
So my plan is to redo (upgrade?) the brakes.
Upgrade the exhaust.
Rebuild the carb and properly jet it.
Remove all fairings and put frame sliders.
Bend back or replace handlebars.
Replace clutch.
Rebuild the starter.
Replace all levers.
Upgrade alternator if possible.
If upgrading the alternator is possible then I will also upgrade the lights and redo the awful wiring.
I would like everyone's thoughts, opinions and recommendations on this project.
So now I've decided that I might as well turn it into a project bike.
So my plan is to redo (upgrade?) the brakes.
Upgrade the exhaust.
Rebuild the carb and properly jet it.
Remove all fairings and put frame sliders.
Bend back or replace handlebars.
Replace clutch.
Rebuild the starter.
Replace all levers.
Upgrade alternator if possible.
If upgrading the alternator is possible then I will also upgrade the lights and redo the awful wiring.
I would like everyone's thoughts, opinions and recommendations on this project.